Cobot Welder, powered by beacon, Periodic Maintenance
Item | Location | Daily | Weekly | Monthly | Quarterly |
---|---|---|---|---|---|
Contact Tip | Torch | ✅ | |||
Air Filters | Robot Cabinet | ✅ | |||
Nozzle1 | Torch | ✅ | |||
Retaining Head2 | Torch | ✅ | |||
Liner3 | Torch | ✅ | |||
Drive Rolls4 | Feeder | ✅ |
- Change nozzle if spatter does not readily come off
- Change the retaining head if the gas ports become clogged
- Change the liner if the wire does not feed smoothly
- Change the drive rolls if slippage is noticed
#
Robot Controller Air Filter MaintenanceThe robot controller contains two air filters, one located on each side of the control cabinet.
- Gently remove the outer plastic frame, by pulling where the red arrows are shown. The frame will tilt out.
- Remove the filter to clean it. Clean using low pressure air or replace filters if necessary. Remember to clean each side.
|